**NOTE: Most of the interaction tools display information about data points from the currently drawn sweep. Because of this, the interaction tools are best used during playback of pre-recorded files where playback can be paused to look at a single sweep indefinitely.
**NOTE: By default the visualizer is in "Camera Mode" meaning you can navigate the visualizer pane using the mouse. Because the tools involve mouse interaction, "Camera Mode" is NOT supported while in "Tool Mode". You can always get back to "Camera Mode" by deselecting the active tool or by pressing the camera mode button on the top left of the visualizer tool bar.
Selecting a tool:
1. Press the button for the desired interaction tool. The tool buttons are located on the top right of the visualizer tool bar. Selecting any tool will disable the camera and put the visualizer in "Tool Mode". The upper right hand corner of the "Visualizer" tab shows the current mode and the active tool type.
2. Use the tool.
3. You can stop using the tool by clicking the "Camera Mode" button on the top left of the visualizer toolbar, or by clicking the specific tool's button a second time.
Info Display Tool
Once the "Info Display" is the active tool type, simply click on any of the sensor readings in the graphical visualizer to display a tiny overlay box with the position of the clicked sensor reading.
Tape Measure Tool
Once the "Tape Measure" is the active tool type, simply click on any of the sensor readings in the graphical visualizer to start measuring a line. Click on a second sensor reading to draw a line between the two data points and display a distance.
Data Table Link Tool
Once the "Data Table Link" is the active tool type, simply click on any of the sensor readings in the graphical visualizer to automatically bring up the corresponding entry in the "Data Table" tab. This allows a means of quickly viewing all the raw data associated with a specific point, simply by clicking on it.